[Tugindia] tugindia Digest, Vol 54, Issue 8

[S. venkataraman]

> -----Original Message-----
> From: tugindia-bounces at tug.org [mailto:tugindia-bounces at tug.org] On
Behalf
> Of David Owen
> Sent: Sunday, July 01, 2007 11:30 PM
> To: tugindia at tug.org
> Subject: Re: [Tugindia] tugindia Digest, Vol 54, Issue 8
> 
> Hi, Everyone,
> Thanks for your help with "Margins 1in all round".
> I got nice results with: \usepackage[margin=1in]{geometry}. In the DVI
the
> margins were like almost 1.25in but when I printed it the left margin
was
> smaller than the right one. I do not know what to do now. The other
> suggestions had margins which were slightly different. Any
suggestions?
> Thanks again for help.
> Regards,
> D.Owen
Try printing a test page that comes with the tex distribution.
This test page prints a black square.  You can adjust your printer
output accordingly. I have forgotten the details now. You can 
look at the UKTUG FAQ for details.
Best regards,
[S. venkataraman]