[lucida] Installation Lucida in Texmaker

[Willem van Leeuwen]

Dear Axel,

Thanks for the letter below.  I will try and let you know.  A last question: how do I reply to `the list’, as you call it? Is that lucida at tug.com?

Willem

Verzonden vanuit Mail voor Windows 10

Van: Axel E. Retif
Verzonden: zondag 22 december 2019 23:16
Aan: Bruno Voisin; Willem van Leeuwen
CC: TeXnical discussion of the Lucida fonts.
Onderwerp: Re: [lucida] Installation Lucida in Texmaker

Willem,


On 12/22/19 8:44 AM, Bruno Voisin wrote:

> On Unix and Mac there are two ways to run updmap to do this: for a system-wide install it's
> 
> 	sudo updmap-sys --enable Map lucida.map
> 
> (where sudo makes the command be run as admin user) and for a user-specific install it’s
> 
> 	updmap --enable Map lucida.map
> 
> Again, you’ll have to experiment to find out how to do the same on Windows.


If I remember correctly, from the time I used Windows 7, to use 
updmap-sys you have to open the Command Prompt with administration 
privileges, or something like that; so just

     updmap-sys --enable Map lucida.map

If you installed Lucida in texmf-local, just forget about «updmap» and 
always use «updmap-sys».

If at any point you make a mistake, don't worry, just run

     updmap-sys --syncwithtrees

and then again

     mktexlsr

     updmap-sys --enable Map lucida.map


Best regards

Axel

P.S. Remember to reply to the list.

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://tug.org/pipermail/lucida/attachments/20191223/8e81f7c7/attachment.html>