[pstricks] strange behavior in pst-3d

[Michael Sharpe]

On Jul 22, 2011, at 2:22 PM, Nitecki, Zbigniew H. wrote:

> The fairly simple code in the attached tex file generates the (correct) picture attached below.
> However, when I copy this piece of code into a (much) larger file, inside a figure environment, the dashed line defined on the line indicated appears horizontal, basically touching the lower
> corner of the horizontal square (unfortunately, I don't know how to take that output and attach it here, without attaching the whole 35-page output in which it is embedded).  What could cause this, and how do I test for it?
> 
> 
> 
> <Newpst3dtest.tex>
> <Newpst3dtest.pdf>
> 
> 

You can burst your large pdf into single pages using

texexec --pdfsplit filename.pdf

and attach the page of interest.

Michael